9 replies
by vramji
by jfara
by gbworld
Make sure the second hard drive is set up properly. On each IDE cable you can set up one master and one slave. Your hard disk manual should have the settings. If both hard drives are on the same cable, the second will have to be set as a slave. You will have to move some jumpers to do this (Read the Manual).
You might also reboot and go into BIOS settings and make sure that it supports a second drive with its current settings.
Note that you may have one drive (your first) set to where IDEfigures out what drive it is. If so, the second drive will have to have the same setting.
Gregory A. Beamer
MVP; MCP:+I, SE, SD, DBA
******************************************
Think Outside the Box!
******************************************
by jfara
by danpiers
by jfara
by greggen
by jfara
by jfara
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending