Discussion Locked

Unable to see slave drive

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi
It is a Win2K system. The primary drive (C) is formatted FAT32 and the secondary drive (G) is formatted NTFS. The secondary drive is completely accessible when installed on the Win2K machine. However if I slave it onto a different pc running WinXP pro with its primary drive also NTFS I cannot see the above mentioned secondary drive. I have also tried putting this drive into an external usb caddy with exactly the same result. I have tried installing a temporary replacement C drive, formatted NTFS and installed WINXP pro on it in the original system. Still cannot see the slave drive.
Why oh why?

5 replies

by info

Make sure:
The Slave drive is seen in the bios
The Slave drive is seen and imported Foriegn Disk in Disk Management
If the Slave is a Dynamic Disk it will say so in Disk Management

XP Pro can import Dynamic Disk or Basic Disks, but XP Home cannot.

If you bios sees the drive, Disk Management does not you could try to "Rescan Disks" on the disk management Icon. But if bios sees drive and Diskmanager does not you only choice is to put the drive on a computer that drive is seen in, and back it up, and restore to that drive after it is reformatted.

Hope this helps
Info is as is of coarse

by prnsk

Thank you for speedy and accurate advice. I enabled the drive in "Drive Manager" and all is fine now.

Best Regards

by willcomp

If you are connecting on same IDE cable as boot drive, problem may be master/slave settings or drive compatibility. Try connecting slave drive as only drive on secondary IDE controller and see if it appears.

XP Pro should see drive without any problems if it is connected properly and recognized by BIOS.

Dalton

This discussion is closed to new replies.