Discussion Locked

Unattended Installations

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am trying to install Wink2 pro by using an unattended installation file. I have my network distribution share setup and I placed my unattended txt file into the same share. Everything works fine as far as copying the files to the hard drive but itwill not use the unattended file i have provided. does anybody have any ideas as to why it's not reading the unattended txt file once it boots into gui mode. i have made sure the file parameters are fully automated but nothing happens. Any help would be greatly appreciated.
Thanks
Nanci

5 replies

by ð

when you run the setup, make sure you add the unattended switch to the end.
example: winnt /u:

In the answer file, under [Unattended] make sure UnattendMode = FullUnattended

and under [USERDATA] make sure Computername = * or ifdon't want it to automatically generate a computer name, put in a name that's already on the network like the PDC or the Root Tree. This will pop up a GUI mode and allow you to type in a computer you perfer.

by stillatit

You are probably leaving the /unattend switch off the command line.

winnt32 /unattend:ansfilename

Good luck.

This discussion is closed to new replies.