Discussion Locked

Unwanted Black Lines on Display

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
After reinstalling Win95 i get unusual black lines covering sections of text or graphics. These disapear when the screen is refreshed but will apear again in new windows. I have tested with other monitors but this is not the problem. I have seen theproblem on a number of PC's now and therefore do not think that it is a particular faulty graphics card. Any ideas, suggestions comment would be helpful. Cheers.

11 replies

by otl

From what I have seen this is due to;

A. The wrong monitor selected.

B. The wrong video card selected.

C. A conflict between the video drivers for the program and the ones for the monitor / video card.

Fix action is to get the latest video drivers and ensure the monitor is set up correctly, to enclude refresh rate and type. Check the FCC tag on the back (or bottom) of the monitor for verification.

by jwilczyn

Check the video driver and settings. The refreshing rate is very important; if it wasn't set properly you may experience these kinds of problems. From my experience using 75Hz refreshing rate is OK for most of video cards and monitors with resolution 800x600. For old monitors you can use e.g. 60Hz, they may not work with 85Hz or above, you can have strips on the screen or a blank screen with buzzing noise. If you want to go for higher resolution 1600 or so, the best thing is, to check video cards and monitors menus. Again, from my experience, higher resolution - lower refreshing rate.

by darkchilde

Hello,

Have you checked for a virus? It might be some virus that is spreading through your network.

This is just a thought, that you might want to check out.

Hope this helps.

by trichard

Try installing the newest drivers for your graphics card. If that doesn't help, check for IRQ conflicts and clear those up.

Good luck!

by guruofdos

The likely cause of your problem is a faulty ram chip on the graphics card. Black lines and/or random speckling of pixels is a classic sysmptom of the video ram not refreshing correctly or of a faulty address line or data lines on the ram chips. I'massuming here that the card has it's own RAM and is not shared with system RAM. Cirrus Logic and Avance Logic graphics card are notorious for this. Try a new graphics card. Does moving the mouse over the affected image caus changes? If so, then you definitely have a graphic memory problem. Many graphics cards implement hardware cursors and these refresh the area of memory nearer the cursor more often than the standard scan.

This discussion is closed to new replies.