Discussion Locked

Upgrading PDC to Windows 2000

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a PDC that is needing replaced. Once I get the new server in, I will need to move the current PDC to the machine, give it the same name, and upgrade to Windows 2000. Suggestions?

12 replies

by kenalmoore

By default, Windows 2000 Domain Controllers are synchonized, so there is no one "PDC".
I you have 3 Domain Controlers, they share the Active Directory.
You are upgrading hardware, so do a clean install on that machine, upgrade the current PDC, butpromote a BDC and take the PDC offline as a backup if something fails. Upgrade the PDC then and all other BDC's.
When new machine arrive put it online with the others. Please be aware of Active Directory needs to have an active DNS server with a static IP address. WINS is only needed if you have NT4 and 98 clients. If all clients are Win2000 WINS is not needed.

by cricket_moon

Are you suggesting that I install the new machine as an NT BDC, synchronize with the PDC, promote the BDC, and then upgrade it to 2000? Will that work?
The problem is that I have a PDC that I must upgrade to Windows 2000 with the SAME name as ithas now, and the same accounts onto a NEW machine.

by bohicam1

I would take the hard drive out of the existing PDC and place it into the new machine as the primary drive. Install any drivers you may need to conform with the new hardware or move the existing NIC and video cards over. As mentioned above, promote a BDC to PDC first before you do this.
You can then promote it back to PDC when this step is finished.
Now you are ready to upgrade the server to Win2k.
Good luck!

Mike

by cricket_moon

The only big problem with that would be that the old C on the original PDC is an old and decrepid 2GB harddrive. Hence the upgrade to a better box. Plus, we are moving from IDE to SCSI.

by bohicam1

ok then, in that case may I suggest "diskcopy" by powerquest. It is a simple utility that will copy the entire contents of your hard drive over to a new drive. You may then use server magic to increase your C:\ disk space if you choose.
Good luck!
Mike

by oridjinn

Recommended doing this at night, should take approximately 6 hours

Install the PC as a BDC, replicate the servers. Change the current BDC to the PDC and the other server should automatically go back to a BDC. Remove the old PDC (now a BDC). Rename the new PC (now the PDC). Upgrade to Windows 2000.

by expertpc

The SIDs will be ok but I though you wanted the data as well.

Explain why you need the same names.

Your quickest way is to use ghost or disk copy and copy the info to the new drive. Boot the machine and configure all the hardware on the new machine. Also, while you are downloading the drivers to get NT all happy, Download the 2000 ones as well. Test the new machine and make sure it still performs as the NT PDC.

If after a few days of operation there are no problems (BIG NOTE HERE! keepthe other PDC offline during this entire process! Also take not of any new accounts or changes to the domain while this process taes place. This will allow you to rebuild in the case of a failure.)

Now upgrade it to 2000. Run DCPROMO an test test test.

This discussion is closed to new replies.