Discussion Locked

use of cd drive in DOS ( from hd)

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I just lost use of my floppy drive due to a physical problem on the mb side. I was in the process of setting up the following configuration on my own computer: a double hard drive config: both hd's bootable, each with a different operating system: (c:\) (bootable) running WIN98 SE
(d:\) (bootable) running WIN XP
Since I can't have use of the floppy disk anymore, I wondering if there's a way that I can make drive C bootable WITH ACCESS TO MY CD-ROM DRIVES WHEN ITS RUNNING IN DOSMODE, just like a Win98 startup disk? You see I've alrady finished setting up drive C, so I'm hoping that I can start it in DOS mode, and prepare and load everything on drive D from there. And if I could use my CD-ROM drives while Im doing it, it would save me a lot of work.
Also, once I'm done with this, can anyone suggest a good way to create some kind of menu or something from which I would have a choice of which drive I want to start up?starting the machine

3 replies

by thechas

Can you set your system to boot from the CD drive?

If so, you can insert the XP CD in the drive, boot up, and XP will take you through the setup.
No floppy required.
XP should recognize your W98 install on the C: drive, and ask if you want to setup a dual boot configuration.

If you cannot boot from the CD, can you boot off of the C: drive into W98?
Again, just insert the XP CD, and XP should take you through the setup process.

Either way, make sure to specify a location for the XP install.
If you use the default location, it will install onto the C: drive, and wipe out your W98 install.

If you do NEED DOS mode access to your CD drive, you need to install the CD driver in either autoexec.bat, or config.sys

If your system boots, you can download the driver from the CD drive mfg, and install it.

Chas

This discussion is closed to new replies.