Question Locked

Usiing a SATA drive with an IDE Drive

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,

I have a K8T Neo V motherboard. I'm trying to add a SATA drive. A WD SATAII. I would like to mirror the IDE drive, then change the boot sequence using the SATA drive as my main drive.

However, BIOS is not recognizing the SATA drive. The drive is powered up and I've unplugged and plugged the data cable. I'm using a 600 Watt power supply.

I've set the jumper across pins 5 and 6, which I've read will set the SATA drive to SATA I mode.

First, should the BIOS see the drive regardless of the BIOS settings, if the physical connections are right?

Second, how should the BIOS be set? The only reference in this BIOS that I could find to SATA, was under Integrated Peripherals. I changed the On-Chip SATA - IDE Controller from RAID to SATA.

Can anyone point me to some resources?

Am I in the ballpark?

Any help would be appreciated.

Thanks,

Stephen

3 replies

by jamesrl

I know in my case, XP did not see the SATA drive on its own, and I had to have a copy of the SATA drivers for XP on a diskette during the XP install process. This dispite the fact that the BIOS could see the drive just fine.

So I would find out what chipset controllers the sata bus and look for drivers. Mine were adaptec, but of course yours may be different.

James

by oh smeg

As for changing the Boot Order to Boot off the SATA Drive this is unlikely to work as these type of M'Boards allow the IDE to be the Default Drive and any SAT Drives that have been added will be further down the drive chain.

As the basic Boot files to load the SATA Drive will need to be installed onto the IDE Drive so a Clone will not allow the SATA Drive to Boot once the Original OS has been removed from the System either by disconnecting or wiping.

James is also correct a lot of SATA Drives need to have SATA Drivers installed so that Windows can see them and access them. Windows XP itself doesn't support SATA Drives Natively so you need to add drivers for them if you want Windows to see them and work with them in any form.

It would be better to delete the OS Files from the IDE Drive here and then Install the OS to the SATA Drive but you need to remember to press the F6 Key when the First Blue Screen in the Windows Install appears and then when prompted insert a Floppy with the Driver copied to the root of it and press any key to load the SATA Drivers.

If you don't have a Floppy drive available or you can not fit one to perform the base install you can make a New Install Disc by either following the directions here

http://tinyurl.com/326fg3

http://tinyurl.com/2ehzk3

or you can use nLite to make your Own Slipstreamed Install Disc with whatever drivers you may need to add

http://tinyurl.com/e2mo4

If you decide to use nLite make sure that you read the OnLine Directions.

Col

This discussion is closed to new replies.