Discussion Locked

Using all of my hard drive

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I was wondering if anyone could help me with my hard drive. I installed the 60 GB hard drive a while ago and don't exactly remember how I partitioned it. I used a FAT32 partition and it allowed me to partition it to 31.4 GB, but the other 28 odd gigs wasn't partitioned into the drive. At the time, I don't know why, but stupidly, didn't do anything about it, but started using the 31.4 gigs. The drive is about full and I was wondering if there was anyway to get back the space. Using Disk Management in XP it recognizes the disk as only the 31.4 partition and there is no sight of unallocated space on the disk. Thanks for any advice!

5 replies

by techexec2

Here is your punishment for being lazy during the original install :^0 !!

Just kidding...

There is a happy end to your story...

Windows XP can read FAT32 partitions of any size, but will only create them up to 32 GB. This is because FAT32 uses space less efficiently with larger partitions and 32 GB is where Microsoft drew the arbitrary line.

What can you do? Steps:

1. Backup your current 32 GB partition in case something goes wrong during steps 2 and 3.
2. Use Disk Management to convert the partition to NTFS.
3. Use Symantec Partition Magic to enlarge the partition to the full size of the disk.

Happy New Year!

by jamuckley

Hi TechExec2,

Thanks for your advice, but as I converted the FAT32 to a NTFS partition there still was no extra space on the drive to enlarge it to its full size. So I am still stuck.

Any other ideas?

Thanks again,

Jason

by stress junkie

That was my first idea when you said that het Windows disk administrator didn't see any unallocated space. Open the case and look at the label on the hard disk. Make sure that it really is the size that you believe it to be.

One thing to check in disk administrator first. Is the disk set to be a basic volume or a dynamic volume? This really shouldn't cause the problem that you are investigating but if it is a dynamic disk try setting it back to basic. Just for kicks.

by wooly11

Recently recovered a 60 gb which was only showing 32 gb using Seagate Disk Wizard, a dos tool freely available from Seagate.

This discussion is closed to new replies.