Discussion Locked

using nat

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Thank,s ebob,
Still using nat..
That was a very helpful article. But I still have a bit of a problem. When I enter static route what ip adress I'm I putting in there.
My isp's?.. I have a modem hooked up and do not there ip address, I imagine it's different every time.Also to get the win98 to get the internet through the win2000. How would I set up the win98 machine..
Thank's again

3 replies

by 4u21der

To get the other machine to be able to use the connection. Just add the Win2k Internal IP address as a default gateway on the Win98 that will be sharing the connection.

So, if your Win2k box has a internal IP address of 10.10.0.2 just add that address as a default gateway on the Win98 box.

If the connection you are sharing is a Dial-up connection and you want the connection to dial automatically when another computer on your home network attempts to use external resources, click to selectthe "Enable on-demand dialing" check box.

Hope this helps.

Good Luck!

This discussion is closed to new replies.