Discussion Locked

vnc

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Need some expert assistance.

Basically this is what I have.

Network behind a dsl router. Router working as the dhcp server. Win nt server and workstations obtain tcp/ip 192.xxx.xxx.xx1 and 192.xxx.xxx.xx2 from dsl router.

Configured router to open ports 5900-5902 for two workstations with tcp/ip addresses assigned by the router.

With VCN internet access and web browser, I should be able to remotely gain access to the remote computer by entering http://192.xxx.xxx.xx1:5900/. Get a "page cannot be displayed" error.

What am I missing?

Thanks
Mario

5 replies

by hiltont

Hi Mario,

Are you running a web server on these machines? If not, then this is the response you'd expect.

As for vnc, if you connect from the Outside World (OW) to the target, does this work - ie can you access the target's desktop?

If youcan connect to the client and if the client is running a web server, please let me know.

Regards,
Hilton

by mfpchelp

Hilton,

I want to thank you for sharing your knowledge. I may have found the solution to my vnc connection problem. I was using port numbers 5800.... to come in and go out the firewall. To go out I need to use 5900....

Thanks a bunch!
Mario

by mphoffar

I'd look at the IPs you're being assigned. I would suspect that you're ending up with 2 IPs on different subnets. It might be best (and easiest) to narrow your scope for DHCP to hand out 192.168.0.X to ensure both machines will be on the same subnet.

You should be able to test the connection between the two by typing \\ in the run line and see if you can at least pull up a default share

Mark

by mfpchelp

Mark,

I want to thank you for sharing your knowledge. I may have found the solution to my vnc connection problem. I was using port numbers 5800.... to come in and go out the firewall. To go out I need to use 5900....

Thanks a bunch!
Mario

This discussion is closed to new replies.