Discussion Locked

VPN Login Time

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My difficulty is that my VPN Login time is not open enough. I mean I have manager wanting to log onto the network before 6:00am and they can't, but after 6:00am they can. I checked there login time with the User Manager for Domains and there is notime restriction. What else could be stopping there login time? My setup is running an NT 4 server with Microsoft proxy installed.

6 replies

by dheupel

Check to see if the user is a member of a group that has a time restriction. If the user is a member of a group that has time restrictions, then those restrictions will apply to the user. Remember, NT always applies the most restrictive permissionset.

Good luck.

by valachi

The advice is very good but I have one comment. NT DOESN'T always use the most restrictive. Actually NTFS permissions are made by combining the permissions )groups, user etc.) unless No Access is specified for somebody, in which case the result is No Access (because it is set up the first in the ACL and it doesn't checks afterward)

by chad

I found the solution on the microsoft site. I had both TCP/IP and Netbeui running on the VPN server. I took TCP/IP off and just ran with netbeui. Now the service is running fine. I believe that my clients ip numbers were not getting let go by myserver, so when they tried to log back on they couldn't. Now that i just deal with netbeui it is much easier.

This discussion is closed to new replies.