Discussion Locked

VPN ON NT 4.0 DSL ROUTER

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My office is currently using ADSL internet service from Pacbell (part of the SBC Network) with a Cayman 3220 DSL Router. I have successful setup NAT and Pinhole configuration for PcAnywhere connection via TCP/IP. I had to configure the Cayman routerto use specific port TCP and UDP portID for PcAnywhere.

My problem is that I am trying to setup VPN on my WIN NT 4.0 Server with service pack 6 and I can't get it to work. I tried setting up the TCP/UDP port on the router to read my NT SERVER'S STATIC IP ADDRESS. I think I setup the proper adapter (RAS) and PPTP protocol on my NT 4.0 SERVER correctly, but was unable to get it to work properly.

Is there a book or website that I can go to help me with this? I appreciate all the help I canget.

Thanks.

7 replies

by avachon

Hi, your best source will probably be microsoft's technet (there should be plenty of information on the web version if you don't have the cds). Seach suggestions include: VPN, remote access server, ras and nat, pptp. There are plenty of books on rasand vpn, but technet will usually give you the information you need. Also, are there any errors showing up in event viewer that may help isolate the problem? You also might want to enable device.log in the registry and see if that points you in any specific directions. I'm sorry I don't recall the registry path, but again, this is on technet and the corresponding file to look at after device.log is enabled is \winnt_root\system32\ras I hope this helps you out.

by dirk_sg

Follow the instructions on mapping the ports of the router to your NT server. If these ports are not mapped correctly you should recieve a login error to the effect of "The system could not log you in." or it will hang at the authentication stage. If your ports are mapped correctly you may recieve an encryption error. So, ensure that the encryption levels of your server and client correspond . In your troubleshooting of the connection refer to Microsofts Web Site http://www.microsoft.com/technet/network/vpntwk.asp. The situation I ran into that solved some problems with A VPN connecting through a router into a LAN with NAT enabled is that you have to create a LMHosts file that preloads your server so it knows where to look for the login and system resources. feel free to email me with specifics if you still have trouble.

This discussion is closed to new replies.