Discussion Locked

VPN's

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We have recently set up a NT 4.0 server for VPN connections. We have been able to connect to the server, get authenticated and recognized by the domain, but then can only see the box we connect to, no other resources on the network are available. We have been connecting with Windows 98 and 2000. Again both connect to the domain with no problems, but we cannot see resources on the network. What are we doing wrong?

4 replies

by mdavis

Change your RAS configuration to allow access to entire network. Right click on Network Neighborhood, choose properties, go to the services tab, select Remote Access Service, click the properties button, click network, click configure next to the proper protocol, choose Entire Network. OK all the way out and reboot. Good luck.

by rtomasczyk

I was able to solve my problem to this dilema. I tried reversing the cables to the NIC's and it appears that where they are patche into on the network was limiting the ability to see the whole network. As soon as the change was made, the whole network appeared in network neighborhood.

This discussion is closed to new replies.