Discussion Locked

w2k pro Freezing up

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
After, manys days of running w2k pro. It will just freeze up completely out of nowhere. The ctrl + alt + delete doesn't work. What would cause such freeze ups?

5 replies

by gnet158

Have you updated any drivers, BIOS, or hardware? If so then that would be the first place to start. Boot your pc & then press the F8 key to go into SAFE MODE. Check your error logs and go from there. Also did you apply SP1 and have you defraggedyour hard drive after the installation? Make sure you have a large enough swap file. Running low on memory?

by mfranco

I will be doing a full system check of all my drivers. Anything that need to be updated will. thx

by jolly roger

This symptom always suggests checking your CPU fan and Power Supply fan. They can be turning and still cause this symptom (if they're running slow). The best test in this case is to observe the "coast time" of the fan when the system is turned off. An abrupt stop implies something amiss. If all is well check for clogged vents on front and rear of case.

by mfranco

I will be checking out my cpu fan. I had to replace once already. How and where my cpu is placed might be a big issue. thx

This discussion is closed to new replies.