Discussion Locked

w2k will not boot

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i have a pIII 933 dell, i installed w2k over an existing install, and all install completely, but when it got to last thing where you reboot, it now will just sit at the win 2000 splash screen with progress bar about halfway across. any suggestionson how i can fix ? is there a startup disk for w2k to allow format and reinstall or is there a better solution? i have gone into safemode and it just sits at a dos screen on cmd line thanks
steve

9 replies

by jcox303

If possible, a clean install is the best choice. You don't need a boot disk if your BIOS allows your CD ROM to be a boot device. Edit your BIOS settings, pop in the CD and go. If you didn't perform the test upgrade/overwrite to insure your drivers/programs were up to Win2K specs, you will have problems.

by valachi

You can create boot floppies by running:
[cdrom]:\bootdisk\Makeboot.exe a:
This command will create 4 disks. They have to be matching the OS you are installing (i.e. you cannot use W2K Professional CD to create W2K Server boot floppies).
And, also, before you start doing the installation, please, spend some time to check the Hardware Compatibility List to see if all your hardware is recognized by W2K.

by tjswann

Pop in the W2K cd. Boot from it. When asked
for an installation option, choose repair.
Next prompt choose manual. Eventually you
will end up at a 2K command prompt. Type
help. Two of the options are fixmbr and
fixboot. Type Fixmbr /? and fixboot /? for
options. Good luck.

by rguthrie

Do you have any SCSI devices? If so disconnect the SCSI device(S) or remove the card an see if W2K will boot. If so, check the SCSI adapter in Device Manager and add teh devices back in individually. If a device causes a hang on boot check the manufacturers site for new drivers.

This discussion is closed to new replies.