I would run either Raid 1 or 5 for reasons of recovery and minimize data loss.
RAID 1
Level 1 is also referred to as "Mirroring".
A RAID 1 array is very simple, two or more disks act as one logical disk, and data is mirrored between the disks. If you have an array consisting of two 36 GB disks, you will end up with a logical disk of 36 GB, with data being stored on both the physical disks. Hence one of the physical disks can fail, and the array will keep working, and if the disks are hot-swappable, which is the case with most SCSI RAID setups, the failed disk can be swapped for a new disk, and the controller will synch the data between the disks, restoring the array to full functionality, with no downtime. RAID 1 also increases the read performance since both disks can be read at once, while write performance will be more or less identical to that of one single disk. RAID 1 is a good cheap way to achieve good read performance, as well as redundancy.
RAID 5
3 or more disks a required for a RAID 5 array. RAID 5 stores parity information (unlike RAID 1 which stores data redundantly) across the disks in the array, this information can then be used to rebuild lost data in case of disk failure.
So for Raid 1 you will need 2 more HDD's and 4 more for Raid 5.
Hope this helps