Discussion Locked

Where, Oh, Where Did My LPT1 Go?

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

compaq deskpro 4000, win98 4.10, canon bjc-4300, client machine on a win2000 server network, 2 internal hard drives, 1 CDROM drive, 192 MB RAM.

inexplicably, while trying to print to the shared canon bjc-4300, got an error msg stating it was not available. further investigation revealed that i had no lpt1 port. tried reinstalling windows, removing and reinstalling the ecp printer port. Nada!

It only keeps installing the ecp printer port without lpt1 and with the dreaded exclamation before it in the device manager.

the other ports available are com 1 and 2.

Advice, Suggestions?

5 replies

by angsax

It's strange that it suddenly disappeared. As you have an exclamation mark, that suggests a conflict OR drivercorruption. My fix would be to enter the CMOS and check that you have the printer port set to the correct setting. Remove ALL your ports, ECP and COM. Then either refresh from device manger or reboot. 98 is pretty good at redetecting and configuring ports.

by angsax

If it's shared through a switch box, is the switch in the correct position. Sounds silly, but is simple.

by shanghai sam

you're correct, the device status is "either not present or not working properly or does not have all of the drivers installed. (code 10)." However, after reomving ALL ports, 98 detects the ports and for each an "unknown device" after rebooting thecommunications ports are right as rain and the ecp printer port is back with its pesky exclamation point.

There has been no change to the CMOS.

This discussion is closed to new replies.