Discussion Locked

Why won't it boot to a new harddrive???

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a PC with swapable drives. I run 2000Server, NT4 Server, 98, 95. They are all on seperate removable hard drives. I needed to rebuild my machine so I wanted to start with a new install of 98. Now the computer will boot right up with the 2000, NT or 95 drives. It will not however boot to the floppy for the install of 98. All it does is look at the a:\ and then says there is no boot partition. I have tried a new startup disk. I also have tried an NT startup. It is not a bios setting becuase I have made sure it will boot a:,c: then cddrive. I am totally stumped by this...it will not boot to the a:...give me some ideas. Thanks

11 replies

by oneonlysupermouse

This is just an idea but check it out anyway.
It might be something to do with the the bios configuration???? That was my idea

by dmiles

Open my computer and select the drive with Win98,insert the floppy and reboot the system,the boot.ini is looking to the boot files of the primary operating system.

by ahdick

I would love to open my computer but...the machine does not boot so...therefore I can not do that. It has a bootable floppy in the a: so it should work like that but doesn't. Thanks anyway.

by macgyver.hicks

Hi ahdick,
Here are a few questions that came to mind when I saw your question.
1) Have you checked to see if the floppy works when attempting to boot into one of the other drives?
2) Does the drive works while you're in one of the other OS's?
3) If not, have you checked the drives ribbon
cable to cmake sure it is tight? All that moving and vibrating of the box can loosen it.
4) If you done the above, have you tried a floppy drive that is known to be a good one or tested that one in another computer?
5) Have you checked the cable itself to see if it has gone bad?
6) Have you checked the Device Manager in Windows 95 to see if there is a problem listed there with the drive or controller?
Like I said, these just came to mind.
I wish you well.

by ahdick

I checked everything and it does work for the other OS. I am still open for suggestions...thanks

by macgyver.hicks

Hi Again,
You said that you were able to get to the
"a:>" prompt with the boot disk. If so, did you "fdisk" the Win 98 Hard drive? If you did, you will need to run "format" on it. That would give you the "no boot partition" message. If your floppy boot disk doesn't have it, check the Win98 CD. If not there, see if you can get a WinME floppy boot disk and boot with "CD support." That will give you a Diagnostics virtual drive that will have "Format" on it. Then run "Setup" from the CD drive.
I wish you well.

This discussion is closed to new replies.