Discussion Locked

Win 2000 Pro suspend to disk error

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We did a fresh install on a formatted hard drive of Windows 2000 Professional on a Dell Inspiron 3500. When the laptop boots up, it shows a "suspend to disk" error message that the file is missing or a different size. This was a fairly easy fix in98 with the phdisk utility but that doesn't seem to work in Windows 2000. The computer will go into standy but won't come back out necessitating a re-boot. Neither Dell nor Microsoft seem to have a answer to the problem. Any great ideas would be appreicated.

B J. Farrell
bjfarrell@ffdalaw.com

5 replies

by duwaned

Hi.

I am assuming that you just formatted the drive, but didn't FDISK it?

If this is the case, then your old "Save to Disk" partition is still there, and is incompatible with Windows 2000.

Refer to the following article Q254966. This article can be found by going to www.microsoft.com, and doing a search for the number given above.

Pay particular attention to the section marked "More Information". Windows 2000 is the first operating syustem that actually tries to assign a drive letter to a partition which is not a recognised format. Previous versions of Windows never did this.

Save to disk is not supported under Windows 2000 (As the article says).

I am willing to bet that if you delete this old partition, that this error will dissapear, and the machine will succesfully go into standby, and come out. Also make sure though that you never loaded any Dell specific software for the save to disk feature. Remove it if you did.

I hope this helps.
Regards.
Duwane

by philthegreat

This may be related to the boot up system.

Try to re-install the win2000 using it as a boot up CD; and format the disk in NTFS.

This discussion is closed to new replies.