Discussion Locked

Win 95 Client

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Moving old PC running Windows 95 off the Novell server onto Microsoft server. Problem is that the 'Client for Microsoft Networks' is missing as a choice and we are afraid of reloading all of the software on this computer as the settings could be lost. Has anyone encountered this situation and found a successful way to reload the Client without a total reinstall?

13 replies

by ann777

Just go to Start --> Settings --> Control Panel --> Network --> Add --> Microsoft --> Client for MS Networks. After that is installed, then set it to the Primary Logon type.

by maxwell edison

Anna777 is correct, except the sequence of selections in the answer is missing the "client" selection that comes between between "Add" and "Microsoft". (Either double click on "client" or select client then add.)

In addition, you'll want to remove Novell Netware from the components that are installed. Also, if you are logging into an NT Domain, after the Microsoft Client is installed, highlight Microsoft Client(in the Network" window), select properties, check the box marked "Log on to Windows NT Domain", and provide the name of the domain in the space provided.

Be advised, you may be prompted to provide the Windows95 CD to complete the installation process.

Good Luck

Max

P.S.
If you see (in the Network window) IPX/SPX-compatible protocol and/or NetBEUI installed, you'll may want to remove those as well. Remove these if you still can't connect to the network after all of the above is completed.

by cervi_jean

The problem is that when you select client, microsoft Client does not come up as a choice -- the only selection is the Novell. Also, the same happens if you try to select TCP/IP -- no changes can be made. It seems as though these items have been deleted but again, don't want to do a full reinstall of Win 95 for fear of losing this person's settings completely and cannot replace the computer at this moment. Looking for a way to get 'Microsoft Client' back as a choice.

by ann777

You need the Windows CD. You need to ADD the client software as in my original post (as the second poster rectified). ADD the client software. It's on the windows cd.

by cervi_jean

We had a technical 'specialist' come in who looked at the problem and told us that you had to do a 'total install' for Win95 and that we could only install the client component with Win98 and above. What steps do you use to install just the client component of Microsoft client from the CD? That would be the solution if we can do it. Thanks for your help.

by maxwell edison

Perhaps you can try this:
If Windows CLient does not appear as a choice, select the "have disk", and direct it to the Win95 CD. It should find it there.

Max

by ann777

See my previous answer... For ADDING MS Client....
1) Place the Windows cd in the drive
2) Click on Start --> Setting --> Control Panel
3) Double-click on Network
4) Click on the Add button opn the general tab
5) Click on Client
6) Click on Microsoft
7) Click on Client for MS Networks.

Then set it to the Primary Logon type in the box below.

This is a repeat of my first answer (with the "Client" left out, but answerer #2 provided that step).

This should not be a problem.

by ann777

Your note:

"We had a technical 'specialist' come in who looked at the problem and told us that you had to do a 'total install' for Win95 and that we could only install the client component with Win98 and above. What steps do you use to install just the client component of Microsoft client from the CD? That would be the solution if we can do it. Thanks for your help."

Indicates that you are listening to your "professional"... and haven't really tried my first answer. See the word "ADD" ?You must click that button to add that client into your network.

This discussion is closed to new replies.