8 replies
by merced.a Accepted solution
by older mycroft Accepted solution
Which you'll find by looking on the manufacturer's website, of whichever motherboard/chipset you are using. You may have to specify the make of the SATA drive(s) too.
XP didn't install with default SATA drivers, having been developed before SATA hard disk drives had been born.
by bapster Accepted solution
During windows install you should see something at bottom of screen, something like
"Press F6 to load special/other drivers"....(you ahould have previously copied these sata drivers to a cd rom or floppy) point to where you installed the SATA drivers then Windows will allow install on the SATA drive.
by older mycroft Accepted solution
As I mentioned to the other bloke in this thread, the OP already has a working XP install - but it's running from an IDE HDD.
Everyone is assuming the SATA drivers are so that XP will install - not so in this case - XP's already installed. ;)
by merced.a Accepted solution
Thanks, yes I did that.windows did installed but it crashes once the systems tries to come up.It crashes the moment windows comes to the point of starting. I must need the original windows cd that came with the system.
AM
by mohammad oweis Accepted solution
Find in the BIOS configuration an option regarding SATA Native Mode, or anything related to SATA operation (name is different for each BIOS vendor) then disable it, or change it to the other value.
After that try to install Win-XP, now it should see the drive.
by older mycroft Accepted solution
by mohammad oweis Accepted solution
I did not notice that you are trying to add the SATA drive as an additional one, and windows is installed on the IDE drive.
Anyway, Windows-XP can not see SATA drive that run on native mode or with ACHI enabled from BIOS.
If its already enabled, disable it, then go to Computer Management -> Disk Management -> Right click -> Rescan disks.
Theoretically this should work :)
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending