Discussion Locked

win2k boot problems

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

win2k was running fine on a customers PC. Shut down reboot and now (NT DETECT FAILED)
What is the easiest way to resolve this

7 replies

by swetbak

IS there a diskette in the floppy drive?
This is probably the most common reason for the error.

by bentgellerich

This error occurs when ntdetect.com is either missing or has become corrupt. Copy Ntdetect.com from the most recently installed service pack, or from the Windows 2000 Setup boot disk if no service packs have been installed. you could also install w2k again in a different directory. Hope this helps. Email me if you need a step by Step

by dr

DO NOT install the win2k in another Dir.

If it is not a floppy in the floppy drive

1)check the BIOs settings and make sure the bios recognises the disk at it's correct parameters.

If (1) fails then:
2) Use an emergency repair Disk (ERD)
If (2) fails:
3)use a bootable Win2k CD to boot into the recovery console then type FIXBOOT

If (3)fails then:
4)use the bootable Win2k CD to boot into the recovery console then type FIXMBR

If (4) fails
5) you should boot in Fast Recovery

If (5)fails:
6)you will need to reinstall win2k "over the top" by selecting to install a new copy and the pressing R to repair when the system detects that their is an existing install

Good luck
David Ruschinek
PS the order is important

This discussion is closed to new replies.