Discussion Locked

Win2k dir read on CD

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I actually have 2 problems. 1. It seems to take forever to read the directory structure on a CD or CDRW(even longer). 2. I am using adaptec's DirectCD and I'm only able to read the CDRW occasionally on my DVD drive with UDF reader installed. I have all the latest versions/patches.

7 replies

by chad dykstra

This could be related to the CDs you are using...I've found when using cheap CDs they are often not readable in certain drives. Go out and get a couple different brands and see if any of them work consistently for you. I personally use HP CDR discs.

by bestvina

Coincidentally I am using HP CD-RW discs and I haven't noticed if the problem is worse with these or the CD-R disks. But the extended time to read the dirs even happen on purchased CD's. I never had this problem with WIN98 and I've burned hundredsof disks.

by michael roark - ccna/da mcp 3csa

Which version of Adaptec are you using?
that has absolutely NOTHING to do with the read, but only with the write,,
you may want to go figure out what motherboard you have and make sure that you have the best drivers for that IDE bus, all of the data has to flow through the IDE bus, and maybe Win2K and it's new 'Plug and Play' (new to NT-based platforms anyways) didn't load the correct drivers, happened to a friend of mine, and it wouldn't hurt to have better drivers...
Good Luck..

by estebandelatorre

Any CDRW should, at least, be able to read it's own created disk. If this is not possible, the cdrw is bad calibrated.
Since, this, any cd created in this unit will be difficult to read fron any other unit.

This discussion is closed to new replies.