Discussion Locked

Win95 can't see all of my hard drive,

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a win 95 system that I had to buy a new hard drive for. SO I am starting from scratch. I have a 20GB hard drive that I want to use for the win 95 system. Is there a way I can get win 95 to see all 20 GB or atleast most of it. I have trieda few things, but I never can get it to work right. I am able to format and partition atleast 2 4GB drives out of it. But when I go to install Win 95 It only sees 1 hard drive that is 1.99GB and I did enable large disk support. How can I get the OS to see all or most off the 20 GB hard drive.

Any help is appreciated!!

9 replies

by jwilczyn

To work around this behavior for a local hard disk that uses the FAT32 file system, install Microsoft Internet Explorer 4.0 with the Windows Desktop Update component.

Check M-Soft Q127852

by soekratis

Try this out. Do not partition more that 2GB (2048MB) on the first logical drive. Format the drive and install WIN95. Now, once this is done, boot to DOS mode and do a FDISK. Create the secondary partition and format it. Remember, create the secondary only after successfully installing WIN95.

goog luck

regards
Soekratis

by ceo_race

Get the fdisk file from w95 osr2.5 and refdisk your drive. then you will be able to see it all.

This discussion is closed to new replies.