Discussion Locked

Win98 and Nt4 workstation.

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am trying to install a dual boot system with win98 and nt4. Since i already have win98 installed with the fat32 system is there any way to get nt to see that partition so i don't have to do the backup and restore of my hard drive.

5 replies

by avachon

Hi, nt4.0 does not support fat32. Nt needs to place its boot files on C:\ (its system partition) which it cannot do unless the partition is fat16. Rather than do the backup and reinstall routine, you could invest in a utility called partition magic.This will allow you to change the file system on the fly. You can find information about this product at http://www.powerquest.com and it is available at most retail stores such as best buy or compusa (though if you have a little time, it's probablycheaper on online stores). This product also will allow you to change parition sizes on the fly so it is a good utility in many respects. Hope this helps.

by estebandelatorre

follow this steps
1.- Create a fat16 partition say 2GB
Store here the win98 s.o. only, and the boot partition of winnt 4.0.
2.- Create another fat32 partition for win98 aplications (nt can not read fat32)
3.- Create another fat or ntfs partitionto install Windows NT (Win98 can not read NTFS)
4.- Create another partition FAT16 only to share data between win98 and NT

This discussion is closed to new replies.