Discussion Locked

win98 boot up

0 helpful
15 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

When I turn on my computer it says: missing operation system. That means my win98 crashed. Is there any way to fix it without damage my data and fils. I have another hard disk which is runing win98 same edition. my question is that i can copy some files from good disk to bad disk to fix problems?
Any suggestions will help.
Thanks.

15 replies

by syscokid

What you can do is go to the good machine and make a boot disk by going to Control Panel-> Add\Remove Programs-> Windows Setup tab.

Then boot up the bad machine with the disk, and type at the prompt

sys A: C:

and press enter. Then remove the floppy and restart.

If it still doesn't boot, boot from floppy, again enabling cd-rom support when prompted, and reinstall Windows 98 on top of itself. This will restore Windows without damaging your files or data.

by mphoffar

Usually when I saw missing operating system, it came do something changing with how the drive was written to begin with and how it's reading how. You can sys it like the person is answer 1 said...but I don't beleive that's goingto get you anywhere.

Assuming the drive isn't crashed, I would head into the bios, first look for a setting with the drive saying use 32bit and change that from yes to no and then try to boot. IF that doesn't work, again go back into the bios and see if you can redect the orginal settings for the drive. You might want to write down what there to begin with before doing this though.

If neither of those works, I think you're probobly stuck at fdisking and formatting. I doubt if you boot with a bootdisk, you'll see anything on the drive as it is.

Good luck to you

Mark

by imrankasu

After the computer has completed the enhanced BIOS power-on self-test (POST), press the F1 key to enter the BIOS Setup Utility. Verify that the computer memory is 64 megabytes (MB).
Start the computer with the startup disk that was created in Windows? 98 SE or a boot disk.
After starting to the startup disk, verify that the hard disk is recognized. In Fdisk, select Option 4. If no partitions exist, attempt to create a partition. If a partition exists, continue with the next step.
Move a copy of the master boot record from the end of the drive to the beginning. At the C:\ prompt, type: Fdisk/ MBR. Press the ENTER key.
Copy system files to the hard disk using the startup disk that was created in Windows 98 SE. At the command prompt, type: Sys a: c:. Press ENTER.
Perform a clean start of the computer and run a virus scan.

by alan.robinson14

Make Sure your Start up Disk has SYS.COM on it.

When booted up from floppy

key
a:
sys c:

This will transfer system files to the c: drive

Alan

by rgravelle

a) first boot your machine with boot disk
with no cd support.
b) next, run scandisk from a:\ and see what
it says.
c) if it shows no problems, then type
fdisk /mbr.
d) next type sys c:

e) next type cd c:\ and then type dir

f) if you can access c: it should show
the drive contents.If the root
directory shows any garbage then
you have to re-install windows
on top of the old one.

good luck

by flan

uhh... a lot of the answers tell you how to bootup to a dos prompt but how do you copy hundres of MBs? floppy? just take the hard drive out. put it as slave to the one that works and copy what you need. After that lowlevelformat that sucker and reinstall.

This discussion is closed to new replies.