Discussion Locked

Win98 on Omnibook, No CD-Rom

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Whilst installing Win98 on HP Omnibook 5700, after the final reboot in setup, Windows looks for hardware drivers on CD but can't find CD-Rom drive even though it has installled from the CD, only way around is to install real mode drivers from Start up disk by editing config.sys & autoexec.bat. Not happy with this fix as boot speed is compromised. Any clues, Any body. 5700 has CD-rom that is removeable and the floppy fits in same slot or plugs into parallel.

1 reply

by onurzaim

Your Cd-rom drivers should be installed it autoexec.bat and config.sys. If you have Win98 startup diskette or cd rom drivers (also look to your manifacturers site) wirte the neccesary codes. You will need the uniqe cd-rom driver(*.sys)from that diskette and the neccesary lines in Autoexec.bat and config.sys. I hope it wil fix.

If it doesn't look system devices andinstal neccesary IDE driver

This discussion is closed to new replies.