Discussion Locked
0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My Windows 98 clients will not log into my 2K Advanced Server. AD is installed and configured. TCP/IP is configured as the network communication protocol utilizing DHCP. Domain name is correct. Any ideas?
9 replies
by bart777
2 things,
First make sure that you are logging into the 98 machines with the same user id as you are using in the domain.
Second, make sure that the machine is part of the domain.
You should be OK at that point..
Good Luck
by bowl300
The question was auto-closed by TechRepublic
by cxichamp
see q272594 in microsoft knowledge base.You can also run netbui on 98 clients and server.
by bowl300
The question was auto-closed by TechRepublic
by qb
Go into your network properties on your client machines and make sure that you have "client for microsoft networks" installed and then select the properties of that and check that "log into nt domain" box and it the white box put the name of the domain in. Also make sure that "client fo microsoft netwoks" in in the "primary log gon box".
by bowl300
The question was auto-closed by TechRepublic
by chris
If you have not enabled WINS on you 2K server and you are allowing dynamic updates to DNS, then you will have to put the address of your DNS server into your 9x clients configuration. I ran across this as well and after manually entering the DNS address my clients logged in with no problem.
by bowl300
The question was auto-closed by TechRepublic
by bowl300
This question was auto closed due to inactivity
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
2 helpful
24 replies
Discussion
Do you think that business directories are relevant to Local SEO And Lead Generation today
0 helpful
16 replies
0 helpful
6 replies
0 helpful
12 replies
1 helpful
9 replies