Windows Forum

Ask something
Discussion Locked

Windows 2000

0 helpful
1 reply

by ritthy

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I installed Win2000 on top of my window98 os. Things were fine after this step. I accidentally install Client 32 for win95/98, this is when things start to go south. When I reboot, I got a "Winlogin.exe" application error box. Here is the actual error message:
"The instruction at "0x1000204f" referenced memory at "0x1000204f". The memory could not be read" "Ok" to terminate program
"Cancel" to debug the program.

I went in under safe mode and uninstalled the client. When reboot I still have the same problem.

Any suggestions or recommendations as to how I can get my system back the way it were before the client installation?

Thanks,

1 reply

by jesselou

use the lkgc last known good config then sfc/scanonce.if it will not work use the startupdisks or your cdrom winnt32 when challenge to setup and repair select repair
then f for fast repair this will check your drive and verifies all your system files is that of the original and replaced all that was overwritten by your client software.

This discussion is closed to new replies.