Discussion Locked

Windows 2000 Active Directory Problem

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

WINDOWS 2000 ADVANCED SERVER PROBLEM
====================================

We are having a Windows 2000 Advanced Server installed. We have also configured Active Directory on the server. Recently we
have also applied Windows 200 SP2. Since last FEW, days we are having
problems with Active Directory. The Active Directory Consoles (
Users & computers / Domains & trusts / Sites & Services) are not running
properly. These consoles doesnot show up. However, users are able to
login and access the server as usual. The event log for Active Directory
also does not show any errors / warnings.

What can be done to resolve the problem?

8 replies

by mktz

Try running mmc and adding those snap-ins to administrative tools sounds like they were just deleted.

by amit j

Yes, I dis try that also. The snap-ins doenot get loaded in mmc. mmc closes unexpectedly.

Any othe solutions ???

by deltree

I'm assuming you rebooted the DC after applying the SP. If not, REBOOT.
Also, you might try to reapply SP2.

by amit j

I have rebooted the server. also reinstalled SP2 on server as well. Still it doesnot help.

by dgnall

"Beginning with Windows 2000 Service Pack 2, the level of the Support Tools
(Adminpak) must match the level of the service pack that is installed on the
computer."

This is taken from Microsoft article Q292640.

Try re-installing the adminpak.msi. This will give you more tools than are needed, but should also restore the consoles you are looking for.

You can run it from any server that has had SP2 applied. It is located here:
%systemroot%\system32\adminpak.msi

Good luck

by amit j

My other server also running Window 2000 Advanced server is performing fine with SP2. Active Directory is working just fine on it, even after SP2.

Also other admin tools like Computer management etc. are working perfectly.

by ovidiu

Hi,

I need to know some more things about Your problem. DID the AD work after You applied the SP2, or it just stopped working after restarting the DC with w2k SP2?
If it is so, You must reinstall the Active Directory Component, because in W2K Server Family, ther W2K installes without the Active Directory Component, which has to be installed separately.
Reinstall the AD Component, and it should work.

Good Luck

by amit j

After appling SP2 i did restart my server. AD was up with no problem (even today it is running fine !!!). Users are able to login to server & work according to permissions set. BUT THE PROBLEM IS THAT I AM NOT ABLE TO ADMINISTRAT AD. The 3 mmc snap-ins for AD are not getting loaded.....

Any thing else ???

This discussion is closed to new replies.