Discussion Locked

Windows 2000 install trouble

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Having trouble installing Windows 2000 on a client's machine. Nearly every time I boot the compuret with the setup boot disks I get the error message...
During setup
disk I/O error: STATUS=00001000
NTDETECT failed.

12 replies

by raffi_

More info required please.
Is the HDD disk on the HCL?
Have you tried installing directly from the CD?
Previous installations of any OS?
Processor, RAM, Video etc?

Something is trashing NTDETECT before you get a chance to complete the install so I suspect:

1. Faulty or non-standard HDD
2. Previous installation of ????
3. Bad boot/Installation disks (best bet)

Regards
SF

by naamor

I would start from scratch. Fdisk the hard drive. Then make new bootdisks, preferably from a different CD than the one your using now.

Good Luck

by larry

Tried that route but I did not get results. Will try with one more set of disks.

by shmaltz

I have seen this error with the floppy disks. Use the CD (boot to the CD you have to enable this in the bios setup). Or use an image.

by sergey kovzik

I had same problem with SCSI hard drive. I've modified TXTSETUP.SIF to load my drivers and everything went Ok.

Sincerely, Sergey
Brainbench MVP for Win98 Administration

P.S. If you have IDE - try to change geometry translation from LBA to NORMAL

This discussion is closed to new replies.