Discussion Locked

Windows 2000 Installation

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

In Setup Windows 2000, I get an error message:
The following value in the .SIF file used by SETUP is corrupted or missing.
Value 0 on line in section [SourceDisksFiles] with key "SP1.cab"
Setup cannot continue.
This message comes after I formatted the HD with Win2k and after inserting the 4 setup disks.
The system is K6/2/500 MHz, 64MB, 10GB, CDROM, etc
Please help.

3 replies

by curacao_dejavu

This is usually caused by a syntax error in the Setup Information File (SIF) associated with the image you are trying to install.

create a new set of setupdisk.

To create a set of Setup boot disks for Windows 2000, run the Makeboot.exe tool from the Bootdisk folder on the Windows 2000 CD-ROM:

Insert the Windows 2000 CD-ROM in the CD-ROM drive.

Click Start, and then click Run.

In the Open box, type drive:\bootdisk\makeboot a:, where drive is the letter of your CD-ROM drive, and then press ENTER.

NOTE: You do not have to be running Windows 2000 to create the Setup Boot disks. A directory called \Bootdisk resides in the root of the Windows 2000 Setup CD. This directory contains two utilities capable of generating the4 Setup Boot floppies. If you are booted into Windows 9x you will need to run the 32-bit version of this utility called makebt32.exe. If you are in DOS, or booted with a Windows 98 Startup Floppy that has access to the CDROM, you can use the 16-bit version called makeboot.exe.

regards,

Leopold

This discussion is closed to new replies.