Discussion Locked
0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Okay, I'm going to say this as literate as I can. At home we have a Windows 2000 Pro "server" and two PCs connected through hub to it. We have DSL at our house and want to be able to surf the internet/check email through all PCs. We have a firewall running. On the "server" where the DSL is connected we can do all but on the PCs.. sometimes it lets us to sites and sometimes it doesn't. Sometimes it lets us check email other times it doesn't. Do you think this has to do with proxy or DSL through Bellsouth. Does anyone know if they have any kind of monitoring where they could determine that we are using for a network and not just one PC? thanks for any help you can give me.
2 replies
by shanghai sam
You did not say how the DSL is connected to your "server".
If you are using a DSL router, then Bellsouth can not see that you are using more than one computer. All they can see if the DSL router.
If you have a hub, then they can see the IP addresses of each of your computers.
If you have the DSL modem connected directly to one network board in your "server" and a 2nd network board connects the "server" to the others, Bellsouth can only see the one connection. Of course this means you have to manually set IP addresses on each PC.
I hope one of these answers your question.
by ireland
I have the same setup but without a DSL line. I had a similar problem with the Proxy on my server. I am using proxy server 2.0 and had to run the service pack 3 from Microsoft and now its working fine. Maybe that will help
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
1 helpful
16 replies
0 helpful
12 replies
0 helpful
3 replies
0 helpful
2 replies
Question
Is WSL still relevant in 2026?
0 helpful
1 reply