Discussion Locked

Windows 2000 Professional will not boot.

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an HP 8160 with the following specs:
233 Mhz; 128Mb; 6GB. The drive is partitioned in three 2GB partitions. On the first partition I have windows 95, on partition (2) I have Win2K professional, the third is empty. The problem is I am unable to boot Win 2k. Trying to boot in safe mode shows that the puter is hanging when it reaches winnt\System32\Drivers\Mup.sys. How can I solve this problem?

7 replies

by izz

Well, I suspect that this a memory problem. Are all you memory chips compliant with each other. As u have mentioned, well u have 128, if they are the sum of 2 chips try to remove one and boot, if it works then definetly it is RAM problems.

Hope this helps.

by bcccliff

HP 8160 has 4 slots and takes EDO chips. These chips must be installed in pairs. I have 4 32Mb chips so it is not possible to remove one chip. The computer recognizes the 128Mb of RAM.

by erikbutler

boot to a W2k cd and the select repair the install then replace the file that is hanging when it loads with a new copy of it this does not always help but it might in this case

by bcccliff

Tried this but got the same result. The puter will not boot. I wonder if it is something with the PC chipset and whether this puter is Win 2k compatible, I will check the HCL

by jfjester

First you want to check your boot.ini file,
you can check your pc to see if it is windows 2000 complient by going to the i386 directory and using the checkupgrade option-

You may also want to try to do a dual boot option and load both on the first partition, it is trying to pull the boot.ini file from your C: drive in which it is not reading from if your booting from the second partition, you would not have a valid boot sector for it to read from when booting-
I hope this helps

This discussion is closed to new replies.