Discussion Locked

Windows 2000 readiness analyzer woes

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

When upgrading from NT 4.0 (SP 6.0a) to W2K, is there a way to disable the readiness analyzer and force the upgrade? Where exactly does the analyzer check to find incompatible software/drivers? The readiness analyzer tells me the "shuttle sharer parallel port device" is incompatible. This is the driver that allows my printer and scanner (both HP) to share the same parallel port. The patch supplied by HP to fix this problem did not help, neither did uninstalling the software, nor searching the registry and removing all instances of the shuttle sharer command line.
Any help would be appreciated.

5 replies

by avenger

find the .dll's and delete them. Same thing happened to me with 98 to millenium upgrade. there was no program uninstall but I deleted every line referencing the problem .sys file in the registry and it didn't help. I then deleted all instances ofall related files and it worked. Also try going into servises and disabling the shuttle service (may still be there even if you uninstalled) also make sure you disable it in the hardware profile.

Thank you,

avenger

by emblal

The HP patch actually shut down the service, I tried disabling it in the hardware profile and removing related .dll's, all to no avail. I gave up, reformatted, and did a fresh install. I would still like to know, given the blanking of the registry, the removal of the .dll's, and the disabling of the hardware, what exactly the readiness analyzer is checking- and how to defeat it and proceed with the installation.

by james_randy

If you are still tackling this problem, perhaps you should consider calling your local super-hero.

by emblal

You're right, I ended up formatting the drive and starting over. So no answer, but NM

This discussion is closed to new replies.