Discussion Locked

Windows 2000 Server

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have installed Windows 2000 Server on a Compaq model 7470 which has a 533mhz K-6 chip/256mb RAM and all hardware is OEM, except for RAM and new Maxtor IDE 20GB HDD. It will usually hang on boot 2-3 times. I have installed Compaq's Windows 2000 BIOS update and updated all drivers. There are no errors in the event log and I have yet to install any other software on this server. I have also searched Microsoft's internal KB and have found nothing. Has anyone got any ideas?

4 replies

by yagar

When dealing with AMD processors with certain FIC motherboards, I had the same situation.

I had to make sure (in the BIOS)

1. The plug and play option needs turned off, something like "plug and play OS installed"

2. The memory timing had tobe adjusted

This is very general, if you need more assistance e-mail me and I will be more specific

by yagar

B Weaver,

Go to the BIOS of the computer

See if there is an entry that says

"PNP OS installed"

be sure that is set to " NO "

Go to the chip set setup of the BIOS

If there are entries like

EDO read burst
EDO write burst
PRECHARGE time
EDO RAS to CAS timing

Set them to the highest number
example
if the choices are x222 or x333 set it to the x333
if the choices are 2T or 3T set it to 3T

If there is a "MA wait state" set it to "slow"

If you have SDRAM for memory the settings will look like

SDRAM Configuration
SDRAM RAS to CAS
SDRAM RAS Precharge time

Set them to the highest number

I am not sure with the Compaq if you are going to have any of these settings or if the name of them might be a little different. What the objective is , to slow the RAM settings down to see if it will work. If it does you can change them back one at a time until the computer will not boot correctly. The speed difference in the computer if , for the most part, not noticeable

If you do not see the settings for the memory get in touch with Compaq and see if there is a BIOS update for that model. It will probably be on the website. We had one Compaq server that would not boot after installing Service pack 5 for NT, until we updated the BIOS

Let me know how it is going

JP

This discussion is closed to new replies.