Discussion Locked

windows 98 install problem

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi:
I am unable to get a clean install of windows 98 first edition on my computer.
I have had it running for 2 years without much problem, but a few days ago I was getting alot of windows crashes. dll files and etc errors, windows became unstable...
I had removed alot of software recently and have been using my computer mostly for my music recording. Which I know is alot of wear on the hard drive. I attributted the windows crashes to this removal of software.
I decided to back up my files and fdisk and mat, and start a fresh installation.
Now I cannot seem to get a clean installation of win 98, its get to about 10% of the installtion left, does the restart and then I get windows blue screen with messages like Fault in 0E 0028:c00051ef in VXD Vmm(01) etc, also on the boot I get messages like Divid over flow error.
I had replaced the CD rom reader think perhaps its not reading the cd rom of windows 98 clearly but I am still having the same problems. I plan on replacing the Hard Drive and trying it again. But would like to know if its something else before going threw that procedure.
If anyone can give any help, It would be much appreciated.
MY computer specs.
Tiger system, I have a pent 2, 350 mhz BX motherboard. 6.4 gb HD. I wave a scsi Yamah burner, and IDE Cd rom reader.128 mb ram 100 mhz bus...
thanks, Todd

13 replies

by richard_barsby

Hi it sounds like a memory module failure this would account for the errors before and during the reinstall you could try to reseat them/it.

Hope this helps

Rich

by toddmosk

Thank you Richard, when I removed my memorey (64,32,32) and resit them as just 32,32. It seems my problem dissapeared. I am on now and have seem to gotten over this problem. I had installed the 64 a few months ago...
The question remains perhaps i need to put the 64 in slot 3 instead of slot 1.or perhaps it is defectective.
I am waiting a bit till to try this though. just happy to be back and live again...
Thanks again, Todd

by dmiles

You maybe expierencing a hard drive going bad,insert the startup disk in floppy and at command prompt type in fdisk /mbr,then do a partition and reformat of the drive.
Reboot
At the command prompt type in fdisk /s to load the system files for install,this will tell if the drive has bad clusters on it.
VxD is a hardware problem in the kernal that is not communicating,try reseating the memory and the video card.also try updating the bios.

by hdd2002

You can seperate your problem first. take all the parts out except MB & Memory & HD, Video. If it does not work, it should be one of HD, Memory, MB. It is possible that your CPU Fan stopped.
Good Luck.

by toddmosk

Thanks Richard, i did strip my computer down and it seemed to help me get to the solution of removing the extra RAM I had installed a few months earlier.

by hdd2002

You can seperate your problem first. take all the parts out except MB & Memory & HD, Video. If it does not work, it should be one of HD, Memory, MB. It is possible that your CPU Fan stopped.
Good Luck.

by hdd2002

You can seperate your problem first. take all the parts out except MB & Memory & HD, Video. If it does not work, it should be one of HD, Memory, MB. It is possible that your CPU Fan stopped.
Good Luck.

This discussion is closed to new replies.