Discussion Locked

windows 98 & ME peer to peer networking

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

we setup a peer to peer networking with 2 systems only.
One is running on win-98 and the other ME.
I can see the Me computer on the 98 system but I cannot see the 98 system on Me.
Pl. help.
Ths.
-Hamid

9 replies

by sixfourtykilo

Not only do you need to make sure files and folders are shared, check to see that the workgroups match and that if you have your peer-peer set up with network cards that you check the following:
- If static IPs have been given, make sure the firstthree sets of xxx.xxx.xxx match and the last .xxx is unique
- Make sure that they are in the same subnet mask, a generic and simple one to use is the trusty 255.255.255.0
- One other thing to check if you are using network cards; the cable that connects the two cards together must be an uplink cable, where the pin assignments are complete opposite of one another (mirrored).

Good Luck!
640k

by kmerrillt

I had the same problem and it took a while to find out the issues. One is that WindowsME came unfinished. You'll need to download a patch from Microsoft called (272991.usa). You will also want to check and make sure that a registry key is set for networking. Look in REGEDIT\HKEY\LOCAL_MACHINE\SYSTEM\CURRENTCONTROLSET\SERVICES\VXD\VNETBIOS. Keys should be: Netclean 01, Start 00, StaticVxD "vnetbios.vxd".
Use a crossover cable and apply the following.
Setup for home network is as follows:
Windows 98 computer//
Network neighborhood
Client for Microsoft Networks--Quick logon
your Adapter--Bindings=both
Netbieu
TCP/IP--Specify address;192.168.0.2 Mask 255.255.255.0
File and printer sharing for Microsoft Networks
Primary Network Logon--Client for MS Networks
Windows ME computer//
Network neighborhood
Client for MS Networks--Quick logon
your adapter--Bindings=both
Netbieu
TCP/IP--Specify address;192.168.0.1 Mask 255.255.255.0
File and printer sharing for MS Networks
Primary network logon--Client for MS Networks

Don't forget to restart machines after making changes. It might take a few minutes for both PCs to see each other and show up under NetworkNeighborhood.
Also, before restarting ME machine, unplug the crossover cable, restart the machine and then plug the cable into the card.

This discussion is closed to new replies.