Discussion Locked

Windows 98 problem

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,
I have a win98 computer w/a problem.
The computer will not bootup to the desktop. The last thing I see on the screen at bootup is the windows logo screen than I get a line going down the middle of the screen. I cannot get to safe mode to check the video settings. I can use the w/98 startup disk and get to the dos prompt and see all the files.Is there another aprroach I could take to get to the video settings if that might be the problem.. Any help would be appreciated. Thanks in advance...

11 replies

by frank k

If you can get a DOS prompt, change to c:\windows and type "scanreg /fix". When it's done, type exit and see what happens.

Is this a new computer? Recently upgraded or new peripherals added?

When the machine is booting up there is usually a few seconds when you are able to hit a key or a series of keys that would allow you to edit the config.

by cesarcastro

Two last chances to this terrible case:
1. If you have the installation files and serial number (\windows\options\cabs) you may intent a soft re-installation over the actual one. That will let all the software installed (office, etc.) to continue to operate.
2. After that, if it did not fuction, you would try to reinstall the whole thing: a longly option.
Additionaly, your config.sys and autoexec.bat might have the lesser commands (no special drivers).
A bad Ethernet card malfunction or badsecto on the hard disk, lead to this type of booting problem also.
Finally, have you updated or installed an antivirus program?..
Good luck

by saihib

You can get to Safe Mode. If the last thing you see is the Windows logo screen that means that Windows has already started. At boot, in Win98, hold down the ctrl key, not F8. Once in Safe Mode, delete your video driver and install the standard 640x480 VGA driver. Reboot. Have the latest drivers for your video card handy and re-install. There may be other issues that you're not mentioning. If you think of something else, please post a comment.

by terry_v

Try using the dos editor to channge autoexec.bat and/or config.sys and/or win.ini files to change display drivers. To determine if you have a boot sector virus type "mem" at the dos prompt. conventional memory should be reported as 655,360 bytes. Ifmem reports it as less then you pobly have a virus. Look for a bootlog.txt file and open it in editor look for a line that says something like "Int13 hooked by..." This also indicates a virus. To create a bootlog press F8 when you see the message "starting windows 98" and use the options that come up. Also you may be able to get into safe mode from there. Using the step through commands option may be useful, as it enables you to skip lines in autoexec and config. The dos editor should be on your startup disk. E-mail me vickers_terry@yahoo.com for more info if you are still stuck. I had similar probs with win 95.

by hurricane

i would reinstall windows 98. use your startup disk and tell it to start with cd rom support. when done, change to your cdrom drive. then type setup. this will install windows 98 over the top of the one already there. you will not loose any thing onyour computer by doing this.

This discussion is closed to new replies.