Discussion Locked

Windows 98 SE won't Install, Hangs

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

When installing Windows 98 SE from the CD or the harddrive, will not install. Installation hangs after initial "copying of setup files" or after receiving the following error message, "True Type Fonts detected." After receiving error message, attempts to use "setup" command causes system to default to "D:\" or "C:\" prompt respectively based on install location.

Hard drive condition is formated along with "fdisk /mbr."

Additional note: Same condition exists when attempting to install Windows 95.

9 replies

by borg7of9

First, is there anything on the hard disk now? If so I first suggest erase all the font files, and if that doesnt work, re-format the hard disk. I have also had this happen due to a bad cd but because you can make the problem happen with 98 and 95 Idont think this applies. The have had many windows installs freeze up due to hardware, and the first thing I alway try is to change memory and if I dont have any to change, I remove a some, try again, and if that doesnt work, out it back and remove another.
Hope this helps

by computab

You could spend ages swopping hardware, but how do you know what you have fitted is working. I suggest you need to get a good testing package such as PC-check. It tests motherboard, RAM, disks, processor, ports comprehensively and reports faults.

by @lberto

My solution could be very radical, but it should work. Get a Windows 98 Boot disk (Clean) from someone else's pc. Run Fdisk, build the partition again, format your new partition with format c: /s /u /v and try to install Windows again. It is weird that even if you are try a clean installation it says that you have a True Type fonts detected. It could be a virus resident on memory and/or your boot disk it has a virus on it.
Give it a try.

Good luck,
@lberto

This discussion is closed to new replies.