Discussion Locked

Windows ME and IWill Via Apollo Pro MoBo

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have been using Windows ME for awhile now and have recently updated the BIOS on my MOBO to the latest one available from Iwill.com....At the same time I upgraded my processor from a Celeron 433 to a Pentium III 700E with 100mhz Dimms. Everything appears fine whenever I boot up, but after only a few minutes of operation my system crawls whenever I launch into Quake3Team Arena or any application that uses any significant amount of memory. I did a BIOS reset (which was recommended as part of the update) and nothing seems to help. I have even tried underclocking my processor. I have FDISK and reloaded the system from scratch and this doesn't solve the problem. I have done a thorough system virus check and have not been able to find anything wrong. Is there a known issue with PIII 700E's + ME + Via Apollo Pro Motherboards? If so where can I find the article or your recommendations? I lost my original BIOS when I FDISK'd are reloaded my system so I can't go back to test if the flash was the problem. One note that concerns me is my BIOS application indicates the my process code has been updated to .10???? What does this code mean??????

4 replies

by avachon

Hi, actually I saw something about gaming and the VIA chipset on Tom's hardware: http://www.tomshardware.com
One of my machines runs the VIA chipset (asus motherboard)so I noticed the articles - and the comments I saw were done when testing the chipset on the asus motherboard not IWILL, but I think the problem may be common since it concerns the chipset and not the board maker. Anyway, check out that site, but you may need to search around a bit. Good luck.

by foxja

Didn't answer the question about microcode or give me any details about where on tomhardware.com to find information.

by mark_lt

maybe not the answer, but shouldnt a P3 700 be running with 133mhz ram, not 100 ?

by foxja

Nope the PIII 700E is 100mhz bus, the PIII700EB is 133mhz bus..Purchased that CPU specifically because then I would have to upgrade my RAM....sorry

This discussion is closed to new replies.