Question Locked

Windows Media Player 11 Speaker Setup Help

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I just upgraded to Windows Vista last night, and have Windows Media Player 11 and 5.1 Surround Sound speakers. However, I can only hear sound out of the 2 front speakers and the subwoofer. I tried changing configurations, but it is already set up on 5.1, and when I test the configuration, all speakers work fine. Is there some way to configure my speakers for use with Windows Media Player?

11 replies

by Former member

I have the same problem, i've been looking around the net and it seems quit a few people are having this problem.

However I have not found a solution yet.. somewhere it said something about the sound card drivers not being compatable which cannot be true as i am running vista 32 bit drivers for my sound card.

I am planning on looking on the microsoft site soon, you might want to try that too and i'll keep you up to date in case i find a solution.

by Former member

Mircosoft have decided to removed the hardware abstraction layer (HAL) for Vista which is the piece of software that lets your applications (Windows media player, itunes all that) talk to your sound card.

Basically anything that use's DirectSound3D cannot be used on surrond soundor or other advanced hardware audio features.

Theres a whole article on it here:

http://crave.cnet.co.uk/gamesgear/0,39029441,49287112,00.htm

by Former member

Still on the case, i came across the microsoft forum and one of the ways they said it might fix it is by going to the playback devices >> properties for the sound device your using >> Enhancements >> and then Speaker Fill >> OK

let me know if it works

by come_in_offspinner

Hey guys.
I just tried the Speaker Fill fix, it nailed the centre speaker, so now I've got right, left, sub-woofer and centre working fine, but the two rear speakers are still not working.

Good tip tho, 4 is better than 3. Cheers mate.

by rossen_pomakov

Okay, so i got 5.1 surrond speakers. What i did was say that i have 7.1 surround speakers and configured it that way. Then i selected "speaker fill" and phantom speakers, which splits the sound of the two missing speakers between front and rear. Now I got front center and rear, but for some reason, my Sub doesn't work still...

by eatingjoe23

All speakers but center are working you go into configure your speakers and set them as 7.1, then you remove the side pair, and then i found if you make them not full range, you get all but center! hope this helps!!!

by ryanttucker

IN PLAYBACK TAB, SPEAKERS, CONFIG, I PUT ON 7.1 AND LEFT EVERY BOX CHECKED (I ONLY HAVE 5.1); THEN PLAYBACK TAB, SPEAKERS, PROPERTIES, PUT ON SPEAKER FILL ENHANCEMENT, THEN IN ADVANCED TAKE OFF EXCLUSIVE MODE! THAT SHOULD GET YOU GOING, SOUNDS GREAT!

by dark_dragon00

but dont need to put in 7.1 if u dont have 7.1 just enable fill enhancement

by tang.devonny

I had the same problem... but when I installed Real Player 11 (the free one)

all my speakers now work in WMP11

by selvec

1. Right click on the volume button in the lower right corner of your Vista O.S.

2. Select playback devices

3. Select Speakers and click properties

4. Click the Enhancements tab

5. Check the box called "Speaker Fill"

6. Click Okay or Apply

This discussion is closed to new replies.