Discussion Locked

Windows NT 4.0 Server Login error

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

when logon screen starts an error msg appear:
/systemroot\system32\driver\e100b.sys device driver could not be loaded error status was 0xc000012f.

then when I press Okay on the error message a blue screen with memory dump starts.

how could Isolve this problem? I tried login with last known good configuration it did not work. I did reinstallation of windows Nt 4.0 Server on the same direcotry, but same error.

Regards,

10 replies

by dmiles

The page file may be smaller than the physical amount of ram,this will cause the dump to free up memory
Reference-http://support.microsoft.com/support/kb/articles/Q216/4/91.asp

by magetower

Looks like the e100b.sys is a network card driver. This is your culprit. Check to make sure you have the correct and most current driver loaded for the NIC card. If you do have the right driver then you will probably need to uninstall/re-install thedirver.

by yasser_omran

This is Okay If I can login to the server. But the problem is I could not login. when I pree Ok on the error message at the login screen the blue screen is the next step. My C-Drive is NTFS partition.

by old and tired..

Shut down, and boot with a MS-DOS floppy in A drive (msut have command.com on it!).
This should allow you to get to a C prompt.
Then (hopefully you do have the driver disks/CD for the NIC)....copy the offending file into the directory location your error message says it needs the file to be in.
Luck.

by yasser_omran

My C-Drive is NTFS partition. using MS-Dos floppy will not allow me to access C-Drive because of the NTFS file systm.

by magetower

Further research comes up with the following:

The e100b.sys driver supplied with the NT CD and service packs is not compatible with the Intel 82558 and 82559 network cards. If the NIC in your system is one of these you need to do one of two things.

1. Install a second copy of NT on the system in a different directory without installing network support then obtain a good copy of the e100b.sys from the manufacturer and replace the one on the harddrive.

2. Re-install the system but have the correct diver for the NIC on hand (floppy for instance) and do not let NT auto detect the NIC.

Another thing you didn't mention was whether you tried starting in VGA only mode. This should bypass loading of the NIC drivers and allow you to access the system.

good luck

This discussion is closed to new replies.