Discussion Locked
0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am running windows nt 4.0 at this small charter hs. The software now starts up and gets to the blue screen that indicates the windows nt and then the screen just goes blank. The computer continues to run but I see nothing on the screen. It doesnot go any further then that now. How can I fix this problem? And if the software is corrupt how can I save all of the inofrmation on the HD is i have to reinstall
5 replies
by robwagner
1. When you re-boot, select 'last known good'. See if that allows you into the system.
2. Select VGA mode when re-boot after #1 fails. See if that allows you into the system.
Q: Do you have NTFS partitions on your hard drive?
A: If so, you will need to find an application on the web that allows you to boot with a boot disk and read NTFS formatted drives.
Good Luck!
Rob
by raw280
The question was auto-closed by TechRepublic
by david.slater
Yeah youre video settings might be wrong have you been messing with the resolution becasue you may get a signal out of range error if you have the settings to high for the monitor. I am sure that it is down to your video settings
by raw280
The question was auto-closed by TechRepublic
by raw280
This question was auto closed due to inactivity
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
1 helpful
17 replies
0 helpful
5 replies
0 helpful
12 replies
Discussion
Do you think that business directories are relevant to Local SEO And Lead Generation today
0 helpful
14 replies
0 helpful
2 replies