If you are talking about unable to boot this is a different issue. Two ways to get back to a bootable state. If your cd is bootable then reboot your computer and go into the bios. Set the cd to boot first followed by the floppy disk then the hard drive.
Put your windows 2000 setup cd into the cd-rom drive and start it up. If the system tells you to press any key to boot to the cd press the spacebar or any other key. This will get you to a bootable state and you will be able to modify files etc...
Also, if you created the 4 boot disks using makeboot.exe ( I think that is the exact name but would have to look in the bootdisk folder on the setup disk. Use the one ending in 32 if you are in a 32 bit GUI interface. )
Either method will get you to the point that you can get back in with a known password in a low resolution mode.
Use ntbackup at the run command line to create an emergency repair disk. Put a checkmark in the box where it ask you to back up system state data.
There is an article in Windows 2000 magazine about Win2K recovery and repair in the August 2001 edition.
Hope this helps.