Discussion Locked

Windows Protection Error

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
When trying ot start Windows 98 I get the message "windows protection error - restart your computer" but when I restart the same message comes up. How do I solve this problem so Windows will run properly

7 replies

by ben.snape

Have you got an AMD processor? If so have you got 2 dimms installed? If yes to both, then try taking one of the dimms out.
Also the AMD chip has a clock problem. I've found that reducing the processor speed slightly in the bios settings can solve this.
Also you can download a patch for your AMD (if it is one of course) from the internet that can solve clock problems.
Hope this helps.
Ben

by grbeckmeyer

try looking up MS knowledgebase article Q136337, it will walk you through a process to isolate the problem. If you want to take your chances with skipping the isolation process, my experience is that it is almost always due to corrupt protected mode drivers. Skip right to the "Troubleshooting Protected-Mode Driver Problems". I will also add that my first guess would be a NIC driver or Video driver.

by patrick.lewis

Did you just get done installing or upgrading an application? I had this very problem when upgrading to a newer version of netware client. Starting the computer in safe mode allowed me to remove the netware client software and the computer would then boot without the protection error. I would suggest uninstalling the last application that you installed, to see if that will get you back in.

This discussion is closed to new replies.