Question Locked
0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I installed win xp on a slave drive. When I used it as a master drive it does not boot the OS.
4 replies
by franco.angelo Accepted solution
Clarifications
by brian Accepted solution
ok, if you are asking why, i have a few questions for you...are these IDE drives still (assuming so b/c they are master/slave, or are you talking about SATA 0 SATA 1..etc). Why did you install it originally to the slave drive? Have you tried changing the boot order of the hard drives in the BIOS instead of switching the drive physically from slave to master (or have you changed the jumpers when you changed places on the IDE cable)?
by oh smeg Accepted solution
The Preliminary Boot Files are always copied to the Primary HDD's Root.
When you remove that primary HDD which is always the IDE Chanel 1 Master the Preliminary Boot Files are no longer present and the hardware can not find any files telling it where to find the necessary files to boot from.
Col
by brian Accepted solution
i am assuming that xp was installed when the drive was actually the master drive and you upgraded to different os on new drive....
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies