Discussion Locked
0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Which ports must I open in my firewall to allow WinXP Remote Desktop to function between my home and office? All I can find on the web is "check with your admin". I AM the admin! We don't have a VPN/RAS server setup - we just want to enable the firewall port.
6 replies
at the winxp pc use the command netstat -a to see all active connections, so you can determine which port it is using.
by mr. origami
Right - but it doesn't tell me what service is using what port. I finally found it to be port 3389 - which works fine for Remote Desktop. But - still can't get Remote Web Desktop to work. I changed IIS to use port 8080. I configured my router to"NAT through" ports 8080 and 3389. From my home machine, I can make the initial connection to http://:8080, then adding "/tsweb" to the address bar - but can't establish the remote desktop connection.
RDP uses port 3389.
whoops, didnt see you comments to post #1. To make the RDP connection from the /tsweb client you should supply the internal IP address of the computer you wish to session into.
Also port 8080 is actually all that is needed in this senario as theremote computer (running tsweb) actually runs the terminal session, and sends back the screen updates to your browser over http.
by mr. origami
Poster rated this answer
by mr. origami
This question was closed by the author
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
2 helpful
25 replies
Discussion
Do you think that business directories are relevant to Local SEO And Lead Generation today
0 helpful
16 replies
0 helpful
6 replies
0 helpful
12 replies
1 helpful
9 replies