5 replies
by rcsnapper Accepted solution
by databaseben Accepted solution
firstly, i would double check to ensure the bios settings are accurately recognizing the hard drive. the hard drive would have a label on it with all the tiny details that you can use to set the bios manually.
secondly, i would double check to ensure that the hard drive jumpers are accurately set to "master"
thirdly, i would execute a check disk with the fix option/switch via the xp setup disk recovery/repair console.
lastly, it is unclear how big is the hard drive. but the partition may exceed xp's limit and may need to be repartitioned into smaller 120 gb portions / partitions
by allan.clapp Accepted solution
modern hard drives sometimes have the "Master" setting doubling as "Master/Single" mode. if your hard disk has a seperate jumper setting marked "single" and you are not running a second drive on that disk channel you should use "Single". Otherwise the bios may get confused.
Additionally some BIOS systems (like mine) have their own "Master/Slave" vs "Single" setting for a particular disk channel as well.
by sirsi Accepted solution
1)First check compatibility of hard disk to chip-set of motherboard (Eg an 845 motherboard may not work properly if hard disk capacity is 500GB. if this is ok? then
2) error check partitions using external boot-able (Live CDs) like Hiren CD or Bart PE or Live XP
Hiren CD has lot of stuff Use partition wizard like third party tools to error check file integrity
which may solve your problem
by rcsnapper Accepted solution
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending