11 replies
by drew84 Accepted solution
by chdchan Accepted solution
by drew84 Accepted solution
by thechas Accepted solution
Well,
There should be at least 1 header on the motherboard for adding USB ports. Just check the manual to verify that the wiring of slot bracket cable matches the motherboard wiring.
There also may be a jumper to set which 5 volt power supply supplies power to the USB ports. If you use the wake-on-keyboard function, you need to have the USB port that your keyboard is plugged into set to use the 5 volt standby or PS/2 power.
You can also check the wattage of your power supply and perhaps even replace the power supply. Depending on how many internal drives and USB devices you connect, you may need 450 watts or more power.
If you do replace the power supply, avoid the ones that sell for less than $20. They just don't last very long.
Chas
by drew84 Accepted solution
by jamblaster Accepted solution
I bought an old computer for a couple hundred dollars one time and I had to take it apart and adjust the FireWire and the USB headers because the 'Expert' who owned the shop I bought it from wired them backwards....
Even if you have a new computer I would suggest checking how your USB is wired to the MOBO just in case.
by ashlandit Accepted solution
by zekestone Accepted solution
by ddp095 Accepted solution
by gsystems Accepted solution
Since it does appear you're working with a desktop, is there an add-in video card? I had a situation with an old Gateway (that is still kicking today with a 4200+ AMD Athlon x2) where the video card was dying and threw off my USB power... It wasn't until the card fully died, and was replaced that the USB ports worked as expected...
Just a thought...
by rickc998 Accepted solution
Does it make any difference if you turn off power-saving on the USB hubs?
1. Open 'Device Manager' from the 'Control Panel'.
2. Expand the entry for 'Universal Serial Bus controllers'.
3. Right-click on each 'USB Root Hub' in turn and choose 'Properties'.
4. Select the 'Power Management' tab.
5. Remove the default tick mark from the 'Allow the computer to turn off power to this device' checkbox.
6. Click on 'OK' to dismiss the dialog.
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending